Netgear XSM7224S User Manual download pdf (Page 473)

100

101

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0

Management Commands 7-57

v1.0, November 2010

show snmptrap

This command displays SNMP trap receivers. Trap messages are sent across a network to an

SNMP Network Manager. These messages alert the manager to events occurring within the switch

or on the network. Six trap receivers are simultaneously supported.

The following shows an example of the CLI command.

(Netgear Switch)#show snmptrap

Community Name IpAddress IPv6 Address Snmp Version Mode

Mytrap 0.0.0.0 2001::1 SNMPv2 Enable show trapflags

Term Definition

SNMP

Community

Name

The community string to which this entry grants access. A valid entry is a case-sensitive

alphanumeric string of up to 16 characters. Each row of this table must contain a unique

community name.

Client IP

Address

An IP address (or portion thereof) from which this device will accept SNMP packets with

the associated community. The requesting entity's IP address is ANDed with the Subnet

Mask before being compared to the IP address. Note: If the Subnet Mask is set to 0.0.0.0,

an IP address of 0.0.0.0 matches all IP addresses. The default value is 0.0.0.0.

Client IP Mask A mask to be ANDed with the requesting entity's IP address before comparison with IP

address. If the result matches with IP address then the address is an authenticated IP

address. For example, if the IP address = 9.47.128.0 and the corresponding Subnet Mask

= 255.255.255.0 a range of incoming IP addresses would match, i.e. the incoming IP

address could equal 9.47.128.0 - 9.47.128.255. The default value is 0.0.0.0.

Access Mode The access level for this community string.

Status The status of this community access entry.

Format show snmptrap

Mode Privileged EXEC

Term Definition

SNMP Trap

Name

The community string of the SNMP trap packet sent to the trap manager. The string is

case sensitive and can be up to 16 alphanumeric characters.

IP Address The IPv4 address to receive SNMP traps from this device.

IPv6 Address The IPv6 address to receive SNMP traps from this device.

SNMP Version SNMPv2

Status The receiver's status (enabled or disabled).

1 2 ... 468 469 470 471 472 473 474 475 476 477 478 ... 578 579

Comments to this Manuals

No comments

Netgear XSM7224S User Manual Page 473

Comments to this Manuals

Related products and manuals for Software Netgear XSM7224S