Netgear XSM7224S User Manual download pdf (Page 469)

100

101

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0

Management Commands 7-53

v1.0, November 2010

snmp-server enable traps stpmode

This command enables the sending of new root traps and topology change notification traps.

no snmp-server enable traps stpmode

This command disables the sending of new root traps and topology change notification traps.

snmptrap

This command adds an SNMP trap receiver. The maximum length of <name> is 16 case-sensitive

alphanumeric characters. The <snmpversion> is the version of SNMP. The version parameter

options are snmpv1 or snmpv2. The SNMP trap address can be set using both an IPv4 address

format as well as an IPv6 global address format.

The following shows an example of the CLI command.

(Netgear Switch)# snmptrap mytrap ip6addr 3099::2

Default enabled

Format snmp-server enable traps stpmode

Mode Global Config

Format no snmp-server enable traps stpmode

Mode Global Config

Note: The <name> parameter does not need to be unique, however; the <name> and

<ipaddr | hostname> pair must be unique. Multiple entries can exist with the same

<name>, as long as they are associated with a different <ipaddr | hostname>. The

reverse scenario is also acceptable. The <name> is the community name used

when sending the trap to the receiver, but the <name> is not directly associated

with the SNMP Community Table, See “snmp-server community” on page39.”

Default snmpv2

Format snmptrap <name> {ipaddr <ipaddr|hostname> | ip6addr <ip6addr|

hostname>} [snmpversion <snmpversion>]

Mode Global Config

1 2 ... 464 465 466 467 468 469 470 471 472 473 474 ... 578 579

Comments to this Manuals

No comments

Netgear XSM7224S User Manual Page 469

Comments to this Manuals

Related products and manuals for Software Netgear XSM7224S