Netgear XSM7224S User Manual download pdf (Page 320)

100

101

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0

Quality of Service (QoS) Commands 5-46

v1.0, November 2010

no ipv6 access-list

This command deletes the IPv6 ACL identified by <name> from the system.

ipv6 access-list rename

This command changes the name of an IPv6 ACL. The <name> parameter is the name of an

existing IPv6 ACL. The <newname> parameter is a case-sensitive alphanumeric string from 1 to

31 characters uniquely identifying the IPv6 access list.

This command fails is an IPv6 ACL by the name <newname> already exists.

{deny | permit} (IPv6)

This command creates a new rule for the current IPv6 access list. Each rule is appended to the list

of configured rules for the list.

A rule may either deny or permit traffic according to the specified classification fields. At a

minimum, either the ‘every’ keyword or the protocol, source address, and destination address

values must be specified. The source and destination IPv6 address fields may be specified using

the keyword ‘any’ to indicate a match on any value in that field. The remaining command

parameters are all optional, but the most frequently used parameters appear in the same relative

order as shown in the command format.

Format no ipv6 access-list <name>

Mode Global Config

Format ipv6 access-list rename <name> <newname>

Mode Global Config

Note: The ‘no’ form of this command is not supported, since the rules within an IPv6

ACL cannot be deleted individually. Rather, the entire IPv6 ACL must be deleted

and respecified.

Note: An implicit ‘deny all’ IPv6 rule always terminates the access list.

1 2 ... 315 316 317 318 319 320 321 322 323 324 325 ... 578 579

Comments to this Manuals

No comments

Netgear XSM7224S User Manual Page 320

Comments to this Manuals

Related products and manuals for Software Netgear XSM7224S