Netgear XSM7224S User Manual download pdf (Page 310)

100

101

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0

Quality of Service (QoS) Commands 5-36

v1.0, November 2010

The assign-queue parameter allows specification of a particular hardware queue for handling

traffic that matches this rule. The allowed <queue-id> value is 0-(n-1), where n is the number

of user configurable queues available for the hardware platform. The assign-queue parameter

is valid only for a permit rule.

mac access-group

This command either attaches a specific MAC Access Control List (ACL) identified by <name>

to an interface, or associates it with a VLAN ID, in a given direction. The <name> parameter

must be the name of an existing MAC ACL.

An optional sequence number may be specified to indicate the order of this mac access list relative

to other mac access lists already assigned to this interface and direction. A lower number indicates

higher precedence order. If a sequence number is already in use for this interface and direction, the

specified mac access list replaces the currently attached mac access list using that sequence

number. If the sequence number is not specified for this command, a sequence number that is one

greater than the highest sequence number currently in use for this interface and direction is used.

This command specified in 'Interface Config' mode only affects a single interface, whereas the

'Global Config' mode setting is applied to all interfaces. The VLAN keyword is only valid in the

'Global Config' mode. The 'Interface Config' mode command is only available on platforms that

support independent per-port class of service queue configuration.

Note: The special command form {deny | permit} any any is used to match all Ethernet

layer 2 packets, and is the equivalent of the IP access list “match every” rule.

Format {deny|permit} {<srcmac> | any} {<dstmac> | any} [<ethertypekey> |

<0x0600-0xFFFF>] [vlan {eq <0-4095>}] [cos <0-7>] [[log] [assign-queue

<queue-id>]] [{mirror | redirect} <unit/slot/port>]

Mode Mac-Access-List Config

Note: You should be aware that the <out> option may or may not be available,

depending on the platform.

1 2 ... 305 306 307 308 309 310 311 312 313 314 315 ... 578 579

Comments to this Manuals

No comments

Netgear XSM7224S User Manual Page 310

Comments to this Manuals

Related products and manuals for Software Netgear XSM7224S