Netgear XSM7224S User Manual download pdf (Page 294)

100

101

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0

Quality of Service (QoS) Commands 5-20

v1.0, November 2010

match srcl4port

This command adds to the specified class definition a match condition based on the source layer 4

port of a packet using a single keyword or numeric notation. To specify the match condition as a

single keyword notation, the value for <portkey> is one of the supported port name keywords

(listed below). The currently supported <portkey> values are: domain, echo, ftp, ftpdata, http,

smtp, snmp, telnet, tftp, www. Each of these translates into its equivalent port number, which is

used as both the start and end of a port range.

To specify the match condition as a numeric value, one layer 4 port number is required. The port

number is an integer from 0 to 65535.

DiffServ Policy Commands

Use the DiffServ policy commands to specify traffic conditioning actions, such as policing and

marking, to apply to traffic classes

Use the policy commands to associate a traffic class that you define by using the class command

set with one or more QoS policy attributes. Assign the class/policy association to an interface to

form a service. Specify the policy name when you create the policy.

Each traffic class defines a particular treatment for packets that match the class definition. You can

associate multiple traffic classes with a single policy. When a packet satisfies the conditions of

more than one class, preference is based on the order in which you add the classes to the policy.

The first class you add has the highest precedence.

This set of commands consists of policy creation/deletion, class addition/removal, and individual

policy attributes.

The CLI command root is policy-map.

Default none

Format match srcl4port {<portkey> | <0-65535>}

Mode Class-Map Config

Ipv6-Class-Map Config

Note: The only way to remove an individual policy attribute from a class instance within

a policy is to remove the class instance and re-add it to the policy. The values

associated with an existing policy attribute can be changed without removing the

class instance.

1 2 ... 289 290 291 292 293 294 295 296 297 298 299 ... 578 579

Comments to this Manuals

No comments

Netgear XSM7224S User Manual Page 294

Comments to this Manuals

Related products and manuals for Software Netgear XSM7224S