Netgear XSM7224S User Manual Page 276

  • Download
  • Add to my manuals
  • Print
  • Page
    / 579
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 275
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Quality of Service (QoS) Commands 5-2
v1.0, November 2010
Class of Service (CoS) Commands
This section describes the commands you use to configure and view Class of Service (CoS)
settings for the switch. The commands in this section allow you to control the priority and
transmission rate of traffic.
classofservice dot1p-mapping
This command maps an 802.1p priority to an internal traffic class. The <userpriority>
values can range from 0-7. The <trafficclass> values range from 0-6, although the actual
number of available traffic classes depends on the platform. For more information about 802.1p
priority, see “Voice VLAN Commands” on page 3-50
.
no classofservice dot1p-mapping
This command maps each 802.1p priority to its default internal traffic class value.
classofservice ip-dscp-mapping
This command maps an IP DSCP value to an internal traffic class. The <ipdscp> value is
specified as either an integer from 0 to 63, or symbolically through one of the following keywords:
af11, af12, af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5,
cs6, cs7, ef.
Note: Commands you issue in the Interface Config mode only affect a single interface.
Commands you issue in the Global Config mode affect all interfaces.
Format classofservice dot1p-mapping <userpriority> <trafficclass>
Modes Global Config
Interface Config
Format no classofservice dot1p-mapping
Modes Global Config
Interface Config
Page view 275
1 2 ... 271 272 273 274 275 276 277 278 279 280 281 ... 578 579

Comments to this Manuals

No comments