Netgear XSM7224S User Manual download pdf (Page 23)

100

101

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0

Using the Command-Line Interface 1-11

v1.0, November 2010

Using CLI Help

Enter a question mark (?) at the command prompt to display the commands available in the current

mode.

(switch) >?

enable Enter into user privilege mode.

help Display help for various special keys.

logout Exit this session. Any unsaved changes are lost.

ping Send ICMP echo packets to a specified IP address.

quit Exit this session. Any unsaved changes are lost.

show Display Switch Options and Settings.

telnet Telnet to a remote host.

Enter a question mark (?) after each word you enter to display available command keywords or

parameters.

(switch) #network ?

javamode Enable/Disable.

mgmt_vlan Configure the Management VLAN ID of the switch.

parms Configure Network Parameters of the router.

protocol Select DHCP, BootP, or None as the network config

protocol.

If the help output shows a parameter in angle brackets, you must replace the parameter with a

value.

(switch) #network parms ?

<ipaddr> Enter the IP address.

If there are no additional command keywords or parameters, or if additional parameters are

optional, the following message appears in the output:

<cr> Press Enter to execute the command

You can also enter a question mark (?) after typing one or more characters of a word to list the

available command or parameters that begin with the letters, as shown in the following example:

Exit Go to next lower command prompt

? List available commands, keywords, or parameters

Table 8. CLI Editing Conventions (continued)

Key Sequence Description

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 578 579

Comments to this Manuals

No comments

Netgear XSM7224S User Manual Page 23

Comments to this Manuals

Related products and manuals for Software Netgear XSM7224S