Netgear XSM7224S User Manual Page 224

  • Download
  • Add to my manuals
  • Print
  • Page
    / 579
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 223
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-183
v1.0, November 2010
Software Rev: xxx xxx xxx
Serial Num: xxx xxx xxx
Mfg Name: xxx xxx xxx
Model Name: xxx xxx xxx
Asset ID: xxx xxx xxx
Location
Subtype: elin
Info: xxx xxx xxx
Extended POE
Device Type: pseDevice
Extended POE PSE
Available: 0.3 Watts
Source: primary
Priority: critical
Extended POE PD
Required: 0.2 Watts
Source: local
Priority: low
Denial of Service Commands
This section describes the commands you use to configure Denial of Service (DoS) Control. The
software provides support for classifying and blocking specific types of Denial of Service attacks.
You can configure your system to monitor and block these types of attacks:
SIP=DIP: Source IP address = Destination IP address.
First Fragment:TCP Header size smaller then configured value.
TCP Fragment: IP Fragment Offset = 1.
TCP Flag: TCP Flag SYN set and Source Port < 1024 or TCP Control Flags = 0 and TCP
Sequence Number = 0 or TCP Flags FIN, URG, and PSH set and TCP Sequence Number = 0
or TCP Flags SYN and FIN set.
L4 Port: Source TCP/UDP Port = Destination TCP/UDP Port.
ICMP: Limiting the size of ICMP Ping packets.
Page view 223
1 2 ... 219 220 221 222 223 224 225 226 227 228 229 ... 578 579

Comments to this Manuals

No comments