Netgear XSM7224S User Manual Page 131

  • Download
  • Add to my manuals
  • Print
  • Page
    / 579
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 130
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-90
v1.0, November 2010
no storm-control unicast
This command disables unicast storm recovery mode for an interface.
storm-control unicast level
This command configures the unicast storm recovery threshold for an interface as a percentage of
link speed, and enables unicast storm recovery. If the mode is enabled, unicast storm recovery is
active, and if the rate of unknown L2 unicast (destination lookup failure) traffic ingressing on an
interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate
of unknown unicast traffic will be limited to the configured threshold.This command also enables
unicast storm recovery mode for an interface.
no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value for an interface and
disables unicast storm recovery.
Default disabled
Format storm-control unicast
Mode Interface Config
Format no storm-control unicast
Mode Interface Config
Default 5
Format storm-control unicast level <0-100>
Mode Interface Config
Format no storm-control unicast level
Mode Interface Config
Page view 130
1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 578 579

Comments to this Manuals

No comments