Netgear GS728TP User Manual download pdf (Page 89)

100

101

Configuring System Information

ProSafe M5300 Switch

Trap Configuration

This page displays an entry for every active Trap Receiver. To access this page, click System

 SNMP  SNMP V1/V2  Trap Configuration.

To configure SNMPv1/v2 traps:

1. To add a host that will receive SNMP traps, enter trap configuration information in the

available fields described below, and then click ADD.

a. Community Name - Enter the community string for the SNMP trap packet to be sent

to the trap manager. This may be up to 16 characters and is case sensitive.

b. Version - Select the trap version to be used by the receiver from the pull down

menu:

• SNMP v1 - Uses SNMP v1 to send traps to the receiver.

• SNMP v2 - Uses SNMP v2 to send traps to the receiver.

c. Protocol - Select the protocol to be used by the receiver from the pull down menu.

Select the IPv4 if the receiver's address is IPv4 address or IPv6 if the receiver's

address is IPv6.

d. Address - Enter the IPv4 address in x.x.x.x format or IPv6 address in

xxxx:xxxx:xxxx:xxxxx:xxxx:xxxx:xxxx:xxxx or a hostname starting with an alphabet to

receive SNMP traps from this device. Length of address can not exceed 158

characters.

e. Status - Select the receiver's status from the pull-down menu:

• Enable - Send traps to the receiver

• Disable - Do not send traps to the receiver.

2. To modify information about an existing SNMP recipient, select the check box next to the

recipient, change the desired fields, and then click APPLY. Configuration changes take effect

immediately.

3. To delete a recipient, select the check box next to the recipient and click DELETE.

4. Click CANCEL to cancel the configuration on the screen and reset the data on the screen to

the latest value of the switch.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 529 530

Comments to this Manuals

No comments

Netgear GS728TP User Manual Page 89

Comments to this Manuals

Related products and manuals for Software Netgear GS728TP