Netgear GS728TP User Manual download pdf (Page 500)

100

101

Maintenance

500

ProSafe M5300 Switch

• InitTTL - Enter the initial TTL to be used. The initial value is default value. The InitTTL

you enter is not retained across a power cycle.

• MaxFail - Enter the maximum Failures allowed in the session. The initial value is

default value. The MaxFail you enter is not retained across a power cycle.

• Interval(secs) - Enter the Time between probes in seconds. The initial value is default

value. The Interval you enter is not retained across a power cycle.

• Port - Enter the UDP Dest port in probe packets. The initial value is default value. The

port you enter is not retained across a power cycle.

• Size - Enter the Size of probe packets. The initial value is default value. The Size you

enter is not retained across a power cycle.

3. Click CANCEL to cancel the operation on the screen and reset the data on the screen to the

latest value of the switch.

4. Click APPLY to initiate the traceroute. The results display in the TraceRoute area.

Traceroute IPv6

Use this screen to tell the switch to send a TraceRoute request to a specified IP address or

Hostname. You can use this to discover the paths packets take to a remote destination. Once

you click the APPLY button, the switch will send traceroute and the results will be displayed

below the configurable data.

If a reply to the traceroute is received, you will see:

• 1 a:b:c:d:e:f:g 9869 usec 9775 usec 10584 usec

• 2 0:0:0:0:0:0:0:0 0 usec * 0 usec * 0 usec *

• Hop Count = w Last TTL = z Test attempt = x Test Success = y.

To display the Traceroute IPv6 page, click Maintenance

 Troubleshooting  Traceroute

IPv6.

1. Use IPv6 Address/Hostname to enter the IPv6 address or Hostname of the station you

want the switch to discover path. The initial value is blank. The IPv6 Address or

Hostname you enter is not retained across a power cycle.

2. Use Port to enter the UDP Dest port in probe packets. The initial value is default value. The

port you enter is not retained across a power cycle.

3. Click APPLY to initiate the traceroute.

1 2 ... 495 496 497 498 499 500 501 502 503 504 505 ... 529 530

Comments to this Manuals

No comments

Netgear GS728TP User Manual Page 500

Comments to this Manuals

Related products and manuals for Software Netgear GS728TP