Netgear GS728TP User Manual download pdf (Page 499)

100

101

Maintenance

499

ProSafe M5300 Switch

Traceroute IPv4

Use this screen to tell the switch to send a TraceRoute request to a specified IP address or

Hostname. You can use this to discover the paths packets take to a remote destination. Once

you click the APPLY button, the switch will send traceroute and the results will be displayed

below the configurable data.

If a reply to the traceroute is received, you will see:

• 1 x.y.z.w 9869 usec 9775 usec 10584 usec

• 2 0.0.0.0 0 usec * 0 usec * 0 usec *

• 3 0.0.0.0 0 usec * 0 usec * 0 usec *

• Hop Count = w Last TTL = z Test attempt = x Test Success = y.

To display the Traceroute IPv4 page, click Maintenance

 Troubleshooting  Traceroute

IPv4.

To configure the Traceroute settings and send probe packets to discover the route to a host

on the network:

1. Use IP Address/Hostname to enter the IP address or Hostname of the station you want

the switch to discover path. The initial value is blank. The IP Address or Hostname you

enter is not retained across a power cycle.

2. Optionally, configure the following settings:

• Probes Per Hop - Enter the number of probes per hop. The initial value is default. The

Probes per Hop you enter is not retained across a power cycle.

• MaxTTL - Enter the maximum TTL for the destination. The initial value is default

value. The MaxTTL you enter is not retained across a power cycle.

1 2 ... 494 495 496 497 498 499 500 501 502 503 504 ... 529 530

Comments to this Manuals

No comments

Netgear GS728TP User Manual Page 499

Comments to this Manuals

Related products and manuals for Software Netgear GS728TP