Netgear GS728TP User Manual download pdf (Page 46)

100

101

Configuring System Information

ProSafe M5300 Switch

To enable or disable DHCP service:

1. Use Admin Mode to specify whether the DHCP Service is to be Enabled or Disabled.

Default value is Disable.

2. Use Ping Packet Count to specify the number of packets a server sends to a Pool address

to check for duplication as part of a ping operation. Default value is 2. Valid Range is (0, 2 to

10). Setting the value to 0 will disable the function.

3. Use Conflict Logging Mode to specify whether conflict logging on a DHCP Server is to be

Enabled or Disabled. Default value is Enable.

4. Use Bootp Automatic Mode to specify whether Bootp for dynamic pools is to be Enabled

or Disabled. Default value is Disable.

5. Click CANCEL to cancel the configuration on the screen. Resets the data on the screen to

the latest value of the switch.

6. Click APPLY to send the updated configuration to the switch. Configuration changes take

effect immediately.

Excluded Address Configuration

To configure addresses that cannot be assigned to DHCP clients:

1. Use the IP Range From field to specify the low address if you want to exclude a range

of addresses. Specify the address to be excluded in case you want to exclude a single

address.

2. Use the IP Range To field to specify the high address if you want to exclude a range of

addresses. To exclude a single address, enter the same IP address as specified in IP range

from or leave as 0.0.0.0.

3. Click ADD to add the exclude addresses configured on the screen to the switch.

4. Click DELETE to delete the exclude address from the switch.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 529 530

Comments to this Manuals

No comments

Netgear GS728TP User Manual Page 46

Comments to this Manuals

Related products and manuals for Software Netgear GS728TP