Netgear GS728TP User Manual download pdf (Page 39)

Configuring System Information

ProSafe M5300 Switch

2. Click ADD.

3. Repeat the previous steps to add additional SNTP servers. You can configure up to three

SNTP servers.

4. To removing an SNTP server, select the check box next to the configured server to remove,

and then click DELETE. The entry is removed, and the device is updated.

5. To change the settings for an existing SNTP server, select the check box next to the

configured server and enter new values in the available fields, and then click APPLY.

Configuration changes take effect immediately.

6. Click CANCEL to cancel the configuration on the screen and reset the data on the screen to

the latest value of the switch.

7. Click REFRESH to refresh the page with the most current data from the switch.

SNTP Server Status

The SNTP Server Status table displays status information about the SNTP servers

configured on your switch. The following table describes the SNTP Global Status fields.

The following table displays SNTP Server Status information.

Field Description

Address Specifies all the existing Server Addresses. If no Server configuration exists, a

message saying “No SNTP server exists” flashes on the screen.

Last Update Time Specifies the local date and time (UTC) that the response from this server was used

to update the system clock.

Last Attempt Time Specifies the local date and time (UTC) that this SNTP server was last queried.

Last Attempt Status Specifies the status of the last SNTP request to this server. If no packet has been

received from this server, a status of Other is displayed.

• Other - None of the following enumeration values.

• Success - The SNTP operation was successful and the system time was

updated.

• Request Timed Out - A directed SNTP request timed out without receiving a

response from the SNTP server.

• Bad Date Encoded - The time provided by the SNTP server is not valid.

• Version Not Supported - The SNTP version supported by the server is not

compatible with the version supported by the client.

• Server Unsynchronized - The SNTP server is not synchronized with its peers.

This is indicated via the 'leap indicator' field on the SNTP message.

• Server Kiss Of Death - The SNTP server indicated that no further queries were

to be sent to this server. This is indicated by a stratum field equal to 0 in a

message received from a server.

Requests Specifies the number of SNTP requests made to this server since last agent reboot.

Failed Requests Specifies the number of failed SNTP requests made to this server since last reboot.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 529 530

No comments

Netgear GS728TP User Manual Page 39