Netgear GS728TP User Manual download pdf (Page 266)

100

101

Routing

266

ProSafe M5300 Switch

Interface Configuration

Use the OSPFv3 Interface Configuration page to create and configure OSPFv3 interfaces.

To display the Interface Configuration page, click Routing OSPFv3 Advanced  Interface

Configuration.

To configure an interface for OSPFv3 routing:

1. Interface - The interface for which data is to be displayed or configured.

2. Use Area ID to enter the 32-bit integer in dotted decimal format that uniquely identifies the

OSPFv3 area to which the selected router interface connects. If you assign an Area ID

which does not exist, the area will be created with default values.

3. Use Admin Mode* to select enable or disable. The default value is 'disable.' You can

configure OSPFv3 parameters without enabling OSPFv3 Admin Mode, but they will have no

effect until you enable Admin Mode. The following information will be displayed only if the

Admin Mode is enabled: State, Designated Router, Backup Designated Router, Number of

Link Events, LSA ACK Interval, and Metric Cost. For OSPFv3 to be fully functional, the

interface must have a valid IPv6 Prefix/Prefix Length. This can be done through the CLI

using the IPv6 address command in the interface configuration mode.

Note: *Once OSPFv3 is initialized on the router, it will remain initialized

until the router is reset.

1 2 ... 261 262 263 264 265 266 267 268 269 270 271 ... 529 530

Comments to this Manuals

No comments

Netgear GS728TP User Manual Page 266

Comments to this Manuals

Related products and manuals for Software Netgear GS728TP