Netgear GS728TP User Manual download pdf (Page 260)

100

101

Routing

260

ProSafe M5300 Switch

OSPFv3 Configuration

1. Use Router ID to specify the 32-bit integer in dotted decimal format that uniquely

identifies the router within the autonomous system (AS). If you want to change the

Router ID you must first disable OSPFv3. After you set the new Router ID, you must

re-enable OSPFv3 to have the change take effect. The default value is 0.0.0.0, although

this is not a valid Router ID.

2. Use Admin Mode* to select enable or disable. If you select enable, OSPFv3 will be

activated for the switch. The default value is enable. You must configure a Router ID before

OSPFv3 can become operational. This can also be done by issuing the CLI command

router-id, in the IPv6 router OSPF mode.

Note: *Once OSPFv3 is initialized on the router, it will remain initialized

until the router is reset.

3. Use Exit Overflow Interval to enter the number of seconds that, after entering overflow

state, the router should wait before attempting to leave overflow state. This allows the router

to again originate non-default AS-external-LSAs. If you enter 0, the router will not leave

Overflow State until restarted. The range is 0 to 2147483647 seconds.

4. Use External LSDB Limit to specify the maximum number of AS-External-LSAs that can be

stored in the database. A value of -1 implies there is no limit on the number that can be

saved. The valid range of values is -1 to 2147483647.

5. Use Default Metric to set a default for the metric of redistributed routes. This field displays

the default metric if one has already been set or blank if not configured earlier. The valid

values are 1 to 16777214.

6. Use Maximum Paths to configure the maximum number of paths that OSPFv3 can report

to a given destination. The valid values are 1 to 4.

7. Use AutoCost Reference Bandwidth to configure the auto-cost reference-bandwidth to

control how OSPF calculates default metrics for the interface. The valid values are 1 to

4294967.

8. Use Default Passive Setting to configure the global passive mode setting for all OSPF

interfaces. Configuring this field overwrites any present interface level passive mode setting.

OSPF does not form adjacencies on passive interfaces, but does advertise attached

networks as stub networks.

1 2 ... 255 256 257 258 259 260 261 262 263 264 265 ... 529 530

Comments to this Manuals

No comments

Netgear GS728TP User Manual Page 260

Comments to this Manuals

Related products and manuals for Software Netgear GS728TP