Netgear GS728TP User Manual Page 225

  • Download
  • Add to my manuals
  • Print
  • Page
    / 530
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 224
Routing
225
ProSafe M5300 Switch
RIP
Note: RIP is a licensed feature and is available only on switches that have
an active license installed.
RIP is an Interior Gateway Protocol (IGP) based on the Bellman-Ford algorithm and targeted
at smaller networks (network diameter no greater than 15 hops). The routing information is
propagated in RIP update packets that are sent out both periodically and in the event of a
network topology change. On receipt of a RIP update, depending on whether the specified
route exists or does not exist in the route table, the router may modify, delete, or add the
route to its route table.
From the RIP link, you can access the following pages:
Basic on page 225
Advanced on page 226
Basic
From the Basic link, you can access the following pages:
RIP Configuration (Basic) on page 225
RIP Configuration (Basic)
Use the RIP Configuration page to enable and configure or disable RIP in Global mode.
To display the RIP Configuration page, click Routing RIP Basic RIP Configuration.
To configure the administrative mode of ARP on the switch:
1. Use the RIP Admin Mode field and select Disable or Enable.
2. Click APPLY to update the switch with the change.
3. Click CANCEL to abandon the change.
Page view 224
1 2 ... 220 221 222 223 224 225 226 227 228 229 230 ... 529 530

Comments to this Manuals

No comments