Netgear GS728TP User Manual Page 199

  • Download
  • Add to my manuals
  • Print
  • Page
    / 530
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 198
Routing
199
ProSafe M5300 Switch
4. Use IP Address Configuration Method to enter the method by which an IP address is
configured on the interface. There are three methods: None, Manual, and DHCP. By default
the method is None. Method 'None' should be used to reset the DHCP method.
Note: When the configuration method is changed from DHCP to None
there will be a minor delay before the page refreshes.
5. Use IP Address to enter the IP address for the interface.
6. Use Subnet Mask to enter the subnet mask for the interface. This is also referred to as the
subnet/network mask, and defines the portion of the interface's IP address that is used to
identify the attached network.
7. Use Routing Mode to enable or disable routing for an interface. The default value is enable.
8. Use Administrative Mode to enable/disable the Administrative Mode of the interface. The
default value is enable. This mode is not supported for Logical VLAN Interfaces.
9. Use Forward Net Directed Broadcasts to select how network directed broadcast packets
should be handled. If you select enable from the pull-down menu, network directed
broadcasts will be forwarded. If you select disable they will be dropped. The default value is
disable.
10. Use Encapsulation Type to select the link layer encapsulation type for packets transmitted
from the specified interface from the pull-down menu. The possible values are Ethernet and
SNAP. The default is Ethernet.
11. Use Proxy Arp to disable or enable proxy Arp for the specified interface from the pull-down
menu.
12. Use Local Proxy Arp to disable or enable Local Proxy ARP for the specified interface from
the pull-down menu.
13. Use Bandwidth to specify the configured bandwidth on this interface. This parameter
communicates the speed of the interface to higher level protocols. OSPF uses bandwidth to
compute link cost. Valid range is (1 to 10000000).
14. Use ICMP Destination Unreachables to specify the Mode of Sending ICMP Destination
Unreachables on this interface. If this is Disabled then this interface will not send ICMP
Destination Unreachables. By default Destination Unreachables mode is enable.
15. Use ICMP Redirects to enable/disable ICMP Redirects Mode. The router sends an ICMP
Redirect on an interface only if Redirects are enabled both globally and on the interface. By
default ICMP Redirects Mode is enable.
16. Use IP MTU to specify the maximum size of IP packets sent on an interface. Valid range is
68 bytes to the link MTU. Default value is 0. A value of 0 indicates that the IP MTU is
unconfigured. When the IP MTU is unconfigured the router uses the link MTU as the IP
MTU. The link MTU is the maximum frame size minus the length of the layer 2 header.
17. Click APPLY to update the switch with the changes.
18. Click CANCEL to abandon the changes.
19. Click DELETE to delete the IP Address from the selected interface.
20. Click REFRESH to refresh the web page to show the latest IP information.
Page view 198
1 2 ... 194 195 196 197 198 199 200 201 202 203 204 ... 529 530

Comments to this Manuals

No comments