Netgear GS724TS-100NAS User Manual download pdf (Page 82)

82 | Chapter 3: Configuring Switching Information

GS716Tv2 and GS724Tv3 Software Administration Manual

To display the VLAN Membership Configuration page, click Switching VLAN  Advanced 

VLAN Membership.

To configure VLAN membership:

1. From the VLAN ID field, select the VLAN to which you want to add ports.

2. Click the orange bar below the VLAN Type field to display the physical ports on the switch.

3. Click the lower orange bar to display the LAGs on the switch.

4. To select the port(s) or LAG(s) to add to the VLAN, click the square below each port or LAG.

You can add each interface as a tagged (T) or untagged (U) VLAN member. A blank square

means that the port is not a member of the VLAN.

• Tagged: Frames transmitted from this port are tagged with the port VLAN ID.

• Untagged: Frames transmitted from this port are untagged. Each port can be an

untagged member of only one VLAN. By default, all ports are an untagged member of

VLAN 1.

In the following figure, ports e6, e7, and e8 are being added as tagged members to

VLAN 2.

5. Use the Group Operations field to select all the ports and configure them. Possible values

are:

• Untag All: Select all the ports on which all frames transmitted from this VLAN will be

untagged. All the ports will be included in the VLAN.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 274 275

No comments

Netgear GS724TS-100NAS User Manual Page 82