Netgear GS724TS-100NAS User Manual download pdf (Page 81)

Chapter 3: Configuring Switching Information | 81

GS716Tv2 and GS724Tv3 Software Administration Manual

To configure VLANs:

1. To add a VLAN, configure the VLAN ID, name, and type, and then click Add.

• VLAN ID. Specify the VLAN Identifier for the new VLAN. (You can enter data in this

field only when you are creating a new VLAN.) The range of the VLAN ID is 1–4093.

• VLAN Name. Use this optional field to specify a name for the VLAN. It can be up to

32 alphanumeric characters long, including blanks. The default is blank. VLAN ID 1 is

always named Default.

• VLAN Type. This field identifies the type of the VLAN you are configuring. You cannot

change the type of the default VLAN (VLAN ID = 1) because the type is always

Default. When you create a VLAN on this page, its type will always be Static.

2. To delete a VLAN, select the check box next to the VLAN ID and click Delete. You cannot

delete the default VLAN.

3. To modify settings for a VLAN, select the check box next to the VLAN ID, change the

desired information, and then click Apply. Configuration changes occur immediately.

4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to

the latest value of the switch.

5. To reset the VLAN settings on the switch to the factory defaults, select the Reset

Configuration check box, and click OK in the popup message to confirm. If the

Management VLAN is set to a non-default VLAN (VLAN 1), it is automatically set to 1 after

a Reset Configuration.

VLAN Membership Configuration

Use this page to configure VLAN Port Membership for a particular VLAN. You can select the

Group operation through this page.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 274 275

No comments

Netgear GS724TS-100NAS User Manual Page 81