Netgear GS724TS-100NAS User Manual Page 208
- Page / 275
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
208 | Chapter 6: Monitoring the System
GS716Tv2 and GS724Tv3 Software Administration Manual
Unicast Packets Received The number of subnetwork-unicast packets delivered to a higher-layer
protocol.
Multicast Packets Received The total number of good packets received that were directed to a multicast
address. This number does not include packets directed to the broadcast
address.
Broadcast Packets
Received
The total number of good packets received that were directed to the broadcast
address. This does not include multicast packets.
Total Packets Received with
MAC Errors
The total number of inbound packets that contained errors preventing them
from being deliverable to a higher-layer protocol.
Jabbers Received The total number of packets received that were longer than 1518 octets
(excluding framing bits, but including FCS octets), and had either a bad Frame
Check Sequence (FCS) with an integral number of octets (FCS Error) or a bad
FCS with a non-integral number of octets (Alignment Error). This definition of
jabber is different than the definition in IEEE-802.3 section 8.2.1.5 (10BASE5)
and section 10.3.1.4 (10BASE2). These documents define jabber as the
condition where any packet exceeds 20 ms. The allowed range to detect
jabber is between 20 ms and 150 ms.
Fragments Received The total number of packets received that were less than 64 octets in length
with ERROR CRC (excluding framing bits but including FCS octets).
Undersize Received The total number of packets received that were less than 64 octets in length
with GOOD CRC (excluding framing bits but including FCS octets).
Alignment Errors The total number of packets received that had a length (excluding framing bits,
but including FCS octets) of between 64 and 1518 octets, inclusive, but had a
bad Frame Check Sequence (FCS) with a non-integral number of octets.
Rx FCS Errors The total number of packets received that had a length (excluding framing bits,
but including FCS octets) of between 64 and 1518 octets, inclusive, but had a
bad Frame Check Sequence (FCS) with an integral number of octets
Overruns The total number of frames discarded as this port was overloaded with
incoming packets, and could not keep up with the inflow.
Total Received Packets Not
Forwarded
A count of valid frames received which were discarded (i.e., filtered) by the
forwarding process.
Local Traffic Frames The total number of frames dropped in the forwarding process because the
destination address was located off of this port.
802.3x Pause Frames
Received
A count of MAC Control frames received on this interface with an opcode
indicating the PAUSE operation. This counter does not increment when the
interface is operating in half-duplex mode.
Unacceptable Frame Type The number of frames discarded from this port due to being an unacceptable
frame type.
Multicast Tree Viable
Discards
The number of frames discarded when a lookup in the multicast tree for a
VLAN occurs while that tree is being modified.
Field Description
- GS716T and GS724T Smart 1
- Switches 1
- Technical Support 2
- Trademarks 2
- Statement of Conditions 2
- Revision History 2
- Table of Contents 3
- 4 4
- Table of Contents 5
- Chapter 7 Maintenance 6
- Chapter 8 Help 6
- Table of Contents 7
- 8 8
- Getting Started 9
- Smart Switches 10
- Switch Management Interface 11
- Interface on page 24 14
- Web Access 18
- Network Utilities 19
- Firmware Upgrade 21
- Viewing and Managing Tasks 23
- Using the Web Interface 24
- Figure 2. Menu Hierarchy 25
- Device View 26
- Using SNMP 28
- Interface Naming Convention 29
- IP Configuration 33
- Time Configuration 36
- SNTP Server Configuration 39
- Denial of Service 41
- DoS Configuration 42
- Disable 43
- Host Configuration 44
- Green Ethernet Configuration 46
- License Key 47
- Community Configuration 48
- Trap Configuration 49
- Trap Flags 50
- SNMP v3 User Configuration 51
- LLDP Configuration 52
- LLDP Port Settings 53
- LLDP-MED Network Policy 55
- LLDP-MED Port Settings 56
- Local Information 57
- Ports on page 70 58
- Neighbors Information 60
- Port ID field 62
- Services — DHCP Filtering 65
- Interface Configuration 66
- Port Configuration 70
- To configure port settings: 71
- Flow Control 73
- Link Aggregation Groups 74
- LAG Configuration 75
- LAG Membership 76
- LACP Configuration 77
- LACP Port Configuration 78
- VLAN Configuration 80
- VLAN Membership Configuration 81
- Port VLAN ID Configuration 83
- Voice VLAN 86
- Voice VLAN Port Setting 87
- Voice VLAN OUI 88
- Auto-VoIP 90
- Spanning Tree Protocol 93
- CST Configuration 95
- CST Port Configuration 97
- CST Port Status 99
- Rapid STP 102
- MST Configuration 103
- MST Port Configuration 104
- STP Statistics 107
- Multicast 109
- IGMP Snooping 110
- IGMP Snooping Table 114
- Field Description 115
- MFDB Statistics 116
- IGMP Snooping Querier 119
- Forwarding Database 122
- Dynamic Address Configuration 124
- Static MAC Address 125
- Class of Service 128
- CoS Interface Configuration 129
- Interface Queue Configuration 131
- 802.1p to Queue Mapping 132
- DSCP to Queue Mapping 133
- Differentiated Services 135
- Diffserv Configuration 136
- Class Configuration 137
- Policy Configuration 140
- Service Configuration 145
- Service Statistics 146
- Managing Device Security 149
- Management Security Settings 150
- RADIUS Configuration 151
- RADIUS Server Configuration 152
- Configuring TACACS+ 156
- TACACS+ Configuration 157
- TACACS+ Server Configuration 157
- Configuring Management Access 161
- Secure HTTP Configuration 162
- Certificate Download 163
- Access Profile Configuration 165
- Access Rule Configuration 166
- Port Authentication 168
- Port Summary 173
- Traffic Control 174
- MAC Filter Configuration 175
- MAC Filter Summary 176
- Storm Control 177
- Port Security Configuration 178
- Security MAC Address 181
- Protected Ports Membership 181
- ACL Wizard 183
- MAC Rules 186
- MAC Binding Configuration 188
- MAC Binding Table 189
- IP Rules 191
- IP Extended Rule 193
- IP Binding Configuration 196
- IP Binding Table 198
- Monitoring the System 199
- Switch Statistics 201
- Port Statistics 203
- Port Detailed Statistics 205
- EAP Statistics 211
- System Logs 213
- Memory Logs 214
- FLASH Log Configuration 215
- Server Log Configuration 217
- Trap Logs 219
- Event Logs 220
- Port Mirroring 222
- Maintenance 225
- Device Reboot 226
- Factory Default 226
- Upload File From Switch 228
- Download File To Switch 230
- HTTP File Download 232
- File Management 234
- Dual Image Status 235
- Field Description 236
- Troubleshooting 237
- Traceroute 238
- Online Help 241
- User Guide 242
- Hardware Specifications and 244
- Default Values 244
- Port Characteristics 245
- Quality Of Service 246
- Security 246
- System Setup 247
- Management 247
- Other Features 248
- Configuration Examples 249
- VLAN Example Configuration 251
- Access Control Lists (ACLs) 252
- DiffServ Traffic Classes 256
- Creating Policies 256
- 802.1X Example Configuration 261
- MSTP Example Configuration 264
- Notification of Compliance 268
- FCC Information to User 270
- FCC Declaration Of Conformity 270
- FOR HOME OR OFFICE USE 271
- PY306100037 271
- Numerics 272
- Index 273
- 274 274
- Index 275
Related products and manuals for Software Netgear GS724TS-100NAS
Software Netgear XSM7224S User Manual
(579 pages)
(579 pages)
Software Netgear GS728TP User Manual
(530 pages)
(530 pages)
Software Netgear JGS524E User Manual
(37 pages)
(37 pages)
Software Netgear STM150 User Manual
(95 pages)
(95 pages)
Software Netgear Switch L3 User Manual
(271 pages)
(271 pages)
© 2020, manymanuals.com. All rights reserved. | 0.485 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals