Netgear SC101 User Manual download pdf (Page 24)

PARTITION Unique network identifier for each partition. (This is the

same value that appears in the "ut getpart" command as

UNIQUE NAME.)

LABEL What each partition is named. In this example, the first

partition is "test20gb"

IP ADDR the IP address of each partition on your network.

SIZE(M) size in MB of each partition. The first partition is

20,480 MB, that is, 20 GB.

MicroSan MicroSan found within subnet is either

• "1 MicroSan found within subnet" = 1 physical hard

disk, or 2 physical hard disks which are mirrored.

• "2 MicroSan found within subnet" = 2 physical hard

disks, which are not mirrored

The same LABEL and PARTITION appear on the top and bottom half. This SC101 is

mirrored. If it was not mirrored, then the information on the top and bottom would not

match, but would correspond to how you partitioned each SC101 disk, separately.

4. Type ut. The list of CLI commands for the SC101 appears.

5. All commands start with "ut", e.g., "ut listall". Most commands must be followed by the

rootAddr and other information such as the partitionAddr, the roottoken, or a filename.

• rootAddr = "ROOT IP ADDR" from the "ut listall" command.

• partitionAddr = "IP ADDR" from the "ut listall" command, in the PARTITION section.

• roottoken = The SC101 administration password. If you have not changed it from the

default, it's password.

• filename = The filename of a file that you wish to put on the SC101.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29

No comments

Netgear SC101 User Manual Page 24