Netgear SC101 User Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 29
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
“No Central Storage Device was Found” in SmartWizard
First, check these items:
At least 1 hard disk must be plugged into the SC101.
Hard disks must be ATA6 or later, and configured as "Cable Select" (CS).
Use a wired connection to configure and modify the SC101.
If there is still a problem, see the table below.
No Central Storage
Device was Found
Action
Check the Power LED.
The Power LED light should be lit solid green.
If it flashes green three times periodically, then something is
wrong with the response from the DHCP server.
Was the computer or
SC101 recently
rebooted?
The SC101 takes more than 2 minutes to reboot.
If there are many partitions it takes longer.
Wait a few minutes after rebooting before running the SCM to
locate the disks.
Make sure to shut down and restart in the correct order. See
How To’s or the User Manual.
Are the Microsoft
Security, Socketwatch,
or Socketlock utilities
installed?
These freeware utilities can conflict with the SC101.
Run the utility again, and remove it (Source to uninstall
utilities).
For more information about problems with these utilities, see
reference.
Which firewall is
used?
The SC101 automatically works with the Windows XP
Personal Firewall.
For other firewalls such as Trend Micro Personal Firewall and
Norton Firewall, disable the firewall or open UDP port 20001.
Check the LAN
connections and subnet
setup.
The computer and the SC101 must be connected to the same
LAN and subnet (and not across different routers.
For example, these two IP addresses are not in the same
subnet: 255.255.0.0 for the computer and 255.255.255.0 for
the SC101.
Have the hard disks
been partitioned?
Use the UT commands to see a list of partitions that were
created. See Using the UT Command and the SC101
Command Line Interface.
If there is only the Root partition, this means that you have not
partitioned your hard disks.
Create a new partition as described in section "If a partition
has never been seen on a particular computer" in this article.
Wireless network To keep a wireless connection between your computers and the
SC101, there must regularly be a small amount of data throughput.
The SC101 may drop off when operating at the limits of wireless
range.
IP address from DHCP
server.
See Using the UT Command and the SC101 Command Line
Interface to confirm that the SC101 got an IP address from the
16
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 28 29

Comments to this Manuals

No comments