Netgear WNCE3001-100NAS User Manual

350 East Plumeria DriveSan Jose, CA 95134USANovember 2011202-10876-01v1.0Universal Dual Band WiFi Internet Adapter (WNCE3001)User Manual

Getting Started10Universal Dual Band WiFi Internet Adapter (WNCE3001) Unless you changed the settings on the Firmware Upgrade screen (see Upgrade the

Getting Started11 Universal Dual Band WiFi Internet Adapter (WNCE3001)2. From the menu on the left, select Setup Wizard. The following screen display

1222. Advanced SettingsTo change advanced settings, connect the Internet adapter to your computer, and use your Internet browser to go to http://www

Advanced Settings13 Universal Dual Band WiFi Internet Adapter (WNCE3001)The following table describes the fields in the Device Status screen.Table 1.

Advanced Settings14Universal Dual Band WiFi Internet Adapter (WNCE3001) Show StatisticsOn the Device Status screen, click Show Statistics:Table 2. Sh

Advanced Settings15 Universal Dual Band WiFi Internet Adapter (WNCE3001)DHCP Connection StatusOn the Device Status screen, click DHCP Connection Statu

Advanced Settings16Universal Dual Band WiFi Internet Adapter (WNCE3001) This screen shows whether the Internet adapter is set to get its IP address dy

Advanced Settings17 Universal Dual Band WiFi Internet Adapter (WNCE3001)Restore Settings1. On the Backup Settings screen, click Browse.2. Locate and

Advanced Settings18Universal Dual Band WiFi Internet Adapter (WNCE3001)  To check for firmware and upgrade if it is available:1. From the Internet a

Advanced Settings19 Universal Dual Band WiFi Internet Adapter (WNCE3001)• CTS/RTS Threshold (1-2347): The packet size that is used to determine wh

2Universal Dual Band WiFi Internet Adapter (WNCE3001) © 2011 NETGEAR, Inc. All rights reservedNo part of this publication may be reproduced, transmi

Advanced Settings20Universal Dual Band WiFi Internet Adapter (WNCE3001) • When WPS is running, the LED blinks, alternating between green and amber

2133. TroubleshootingUsing the USB Power CableYou can connect the USB power cable to a USB port on a nearby device. If the Internet adapter is not g

Troubleshooting22Universal Dual Band WiFi Internet Adapter (WNCE3001) If the problem continues, make sure that your Ethernet cable is securely connect

23AA. Factory Settings and Technical SpecificationsFactory SettingsYou can use the Reset button on the rear panel to return your adapter to its fact

Factory Settings and Technical Specifications24Universal Dual Band WiFi Internet Adapter (WNCE3001)Technical SpecificationsFeature DescriptionAntenna

25BB. Notification of ComplianceMaximum Wireless Signal Rate Derived from IEEE Standard 802.11 SpecificationsActual data throughput will vary. Netwo

Notification of Compliance26Universal Dual Band WiFi Internet Adapter (WNCE3001)RF Exposure InformationThe radio module has been evaluated under FCC B

Notification of Compliance27Universal Dual Band WiFi Internet Adapter (WNCE3001)Latviski [Latvian]Ar šo NETGEAR, Inc. deklarç, ka Universal Dual Band

3Table of ContentsChapter 1 Getting StartedUnpack Your Adapter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4Ha

411. Getting StartedUnpack Your AdapterOpen the box and remove the Internet adapter, cables, and installation guide.WNCE3001Ethernet cable USB power

Getting Started5 Universal Dual Band WiFi Internet Adapter (WNCE3001)Hardware FeaturesTop Panel with LEDThe WNCE3001 has one LED, which indicates the

Getting Started6Universal Dual Band WiFi Internet Adapter (WNCE3001) Power Connection OptionsYou can power on your Internet adapter using either of th

Getting Started7 Universal Dual Band WiFi Internet Adapter (WNCE3001) To install your Internet adapter:1. Carefully peel off the protective film cov

Getting Started8Universal Dual Band WiFi Internet Adapter (WNCE3001) 6. Disconnect the Ethernet and USB cables from your computer.7. Connect the Int

Getting Started9 Universal Dual Band WiFi Internet Adapter (WNCE3001)9. Congratulations! Your installation is complete. You can return your computer