Netgear RH348 User Manual download pdf (Page 76)

Reference Guide for the Model RT328 and Model RH348 ISDN Routers

7-2 TCP/IP Configuration

Remote Node Setup

See Chapter 5, “Remote Node Conﬁguration,” for information about using the protocol-

independent parameters on Menu 11.1 - Remote Node Proﬁle. Use the ﬁelds described in

Table 7-1 to set the protocol-dependent parameters.

To set the protocol-dependent parameters:

Select Yes in the Edit IP ﬁeld of Submenu 11.1 - Remote Node Proﬁle.

Press [Enter] to display Menu 11.3 - Remote Node Network Layer Options.

Edit the options described in Table 7-2.

Press [Enter] at the Press ENTER to Conﬁrm... prompt to conﬁrm your selections and

return to the previous menu.

Press [Esc] at any time to cancel your selections.

Continue to the end of Menu 11.1 and press [Enter] to save the selections you made in

Menu 11.3.

Note:

If you are conﬁguring the router to receive an incoming call, you must also set the

default dial-in parameters in Menu 13 (see Chapter 6).

Table 7-1. Fields in Menu 11.1 - Remote Node Proﬁle Fields

Field Description

Rem IP Address Enter the IP address of the router at the remote site. If the remote router uses a

different IP address than the one entered here, the call will be terminated. A static

route will be created to the network address of the remote router. Note that if the

remote network uses a netmask other than the standard class netmask, you must

enter the netmask in the Edit IP Options submenu.

Edit IP Press the space bar to change this ﬁeld to Yes and press [Enter] to display the Menu

11.3 - Remote Node Network Layer Options menu.

Tcpip.fm Page 2 Tuesday, October 10, 2000 3:24 PM

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 141 142

No comments

Netgear RH348 User Manual Page 76