Netgear GS524T User Manual download pdf (Page 28)

cabling guidelines C-2

Return Loss

Return loss measures the amount of reflected signal energy resulting from impedance

changes in the cabling link.The nature of 1000BASE-T renders this measurement

very important; if too much energy is reflected back on to the receiver,the device will

not perform optimally.

All four pairs of the twisted pair are used by 1000BASE-T,unlike 10BASE-T and

100BASE-TX,which use only two of the four pairs of wires within the Category 5.

It is important to ensure that all wires are tested.

The factors that will affect the return loss are

• the number of transition points,as there is a connection via an RJ-45 to another

connector, a patch panel, or a piece of equipment at each transition point.

• removal of the jacket that surrounds the four pairs of twisted cable.It is highly

recommended that, where RJ-45 connections are made,this is minimized to

1-1/4 inch (32 mm).

• pair untwist of any of the twisted pairs. It is important that this be minimized

to 3/8 inch (10 mm) where RJ-45 connections are made.

• cabling or bundling of multiple Category 5 cable.This is regulated by

ANSI/EIA/TIA-568A-3,and can adversely affect all parameters of the

cabling if not correctly implemented.

Near End Cross Talk (NEXT)

This is a measure of the signal coupling from one wire to another,within a cable

assembly,or among cables within a bundle.NEXT measures the amount of cross-talk

disturbance energy that is detected at the near end of the link—the end at which the

transmitter is located.NEXT measures the amount of energy that is “returned”to

the sender end.The factors that affect NEXT and cross talk are exactly the same as

outlined in the Return Loss section.The cross-talk performance is directly related to

the quality of the cable installation.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34

No comments

Netgear GS524T User Manual Page 28