Netgear EVA9150 Owner's Manual download pdf (Page 14)

Universal Remote User Manual

2-6 Programming the NETGEAR Universal Remote

v1.0, March 2009

Programming a Device

To program the device buttons to control a home entertainment device:

1. Locate the codes for the devices you want to program in Appendix A, “Manufacturer’s Codes.

For future reference, write down each device code in the following table:

2. Turn on the home entertainment device.

3. Press a device button on your NETGEAR Universal Remote. You can use any device button

for any type of device. NEATGEAR recommends that you use the device buttons for the

following:

•

TV. Program a TV or mobile LCD device.

•

DVD. Program a DVD player, TV/DVD combo, TV/VCR/DVD combo, portable

DVD player, or mobile DVD player.

•

AUX. Program other types of devices or an additional DVD or TV.

4. Press and hold

SET until the red LED blinks twice.

5. Enter the first five-digit code listed in Appendix A, “Manufacturer’s Codes for your device.

The LED blinks once as each digit is entered. If the code is correct, the LED blinks twice when

the programming is complete.

6. Aim the NETGEAR Universal Remote at the device, and press Power. The device should turn

off. If it does not, repeat these instructions, trying each code for your brand until you find a

code that works. If you cannot find a code that works, see “Searching for a Device Code.

7. Repeat steps these instructions for any additional devices you want to control.

Table 2-1. Device Button Codes

Device

Button

Device Code

TV Code

DVD Code

AUX Code

Note: If the LED does not blink twice, repeat these instructions to enter the code

again.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 49 50

No comments

Netgear EVA9150 Owner's Manual Page 14