Netgear PS121v2 User Manual Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 50
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
NETGEAR USB Multifunction Printer Server PS121v2 User Manual
2-6 Setup
v1.1, September 2006
5. Click Next to proceed to the “Activate Network” stage, where the IP address settings and
device name will be displayed.
The settings recommended by the installation assistant will usually work well.
6. Click Next to continue. If the installation assistant prompts you for a password, type
password in the password field and click OK to continue to the “Verify Settings” stage.
7. If the installation instructions prompt you for a password, type password and continue.
8. When you reach the “Finalize Setup” stage, click Print Test Page to confirm that the
installation of the print server was successful.
9. Click Next and Finish to close the installation assistant.
Figure 2-4
Note: Take a note of the the IP address assigned to the print server. You will need
reserve this address in your router to be permanently assigned to the print
server, and use it to access the Web-based Graphical User Interface.
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 49 50

Comments to this Manuals

No comments