Netgear PS121v2 User Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 50
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
NETGEAR USB Multifunction Printer Server PS121v2 User Manual
2-2 Setup
v1.1, September 2006
Unplug the print server from its power source before cleaning. Use only a slightly dampened
cloth for cleaning. Do not use liquid or aerosol cleaners.
Avoid using this product near water. Exposure to water poses an electric-shock hazard.
Overview of USB Multifunction Print Server Setup
Before you share a printer with the NETGEAR PS121v2 USB Multifunction Print Server, you
should have at least one computer connected to an Ethernet network and have one unused port on
a router. When installation is complete, your network configuration will look similar to the
following:
PS121v2 Default Factory Settings
When you first receive your PS121v2, the default factory settings are shown below. You can
restore these defaults with the Factory Default Restore button on the rear panel as explained in
“How to Restore the Factory Default Settings” on page 1-6.
Before you begin, gather your existing network settings such as the TCP/IP addresses and
networking protocols in use.
Figure 2-1
Network Setting Default Factory Setting
IP Address Provided Automatically via DHCP for
Initial Setup but Must Be Set to Static
IP for Regular Operation
Computers
Print Server
PS121
Printer
Router
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 49 50

Comments to this Manuals

No comments