Netgear PS111W User Manual download pdf (Page 65)

NetGear Print Server Manual

List of FTP Files and Commands Supported by the Print Server

Table FTP Files in the Directory lists the file names that appear in the directory.

FTP Files in the Directory

File Name Purpose Mode

CONFIG Configuration file Read/Write

PSINF Device information Read

DEFAULTC Reset device to default configuration Read

RESET Reset device Read

PASSRESET Clear password Read

SETIP Save current IP address Read

Table FTP Commands lists the case-sensitive commands that are implemented. When a command

requires a parameter, the parameter is shown in italics.

FTP Commands

Command Function

dir Lists files as shown in table FTP Files in the Directory.

get FILENAME Retrieves a file. The only files that can be retrieved are CONFIG and PSINF.

get RESET Resets the print server and terminates the current connection.

get

PASSRESET

Clears the password.

get SETIP

Sets the current IP address as a static IP address.

To avoid an address conflict, do not use this command if a DHCP server assigned the IP address to the print

server.

put CONFIG

Copies the CONFIG file to the print server, overwriting the existing CONFIG file. After using this command to

write a new configuration file, use the get RESET command; all LEDs should turn on and then off while the

print server is resetting.

put

PASSWORD

Copies the password file to the print server and gives it a new password. Passwords can be up to 19 bytes in

length.

put filename Ln Copies the filename file to the printer connected to n port and prints the file.

quit Terminates the current FTP session.

Other FTP commands cannot be used, and they return an Invalid Command error message.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 105 106

No comments

Netgear PS111W User Manual Page 65