Netgear PS100 User Manual download pdf (Page 73)

NetGear Print Server Manual

5-2 Configuring Your Print Server Using FTP

FTP allows a user to log on to a remote host and to manipulate files on the host. The print server can

act as an FTP host. Using FTP, you can access and modify the CONFIG file in the print server.

Modifying the CONFIG file changes the configuration of the print server.

The limitations of print server support when using FTP are:

• Only one FTP user can connect to the print server at a time.

• Only command line FTP programs can be used. FTP programs that attempt to browse the file

system are not supported.

Configuration Example

This section provides commands to use and responses to each command when you use FTP to connect

to the print server.

Example instructions are:

1. Connect to the print server by entering the command:

ftp NAME or ftp IP_Address

You can connect using a name instead of an IP address only if your system has been configured to recognize

the name to IP address association.

2. Enter the default name (on the base of the device) when you are prompted for the user name.

3. Press [Enter] when prompted for the password.

4. Copy the configuration file by entering the command:

ftp>get CONFIG

5. Quit copying the file by entering the command:

ftp>quit

6. Edit the CONFIG file by typing with a text editor.

NETGEAR recommends that you edit the CONFIG file to provide a permanent IP address to the print

server. The CONFIG file is shown in “CONFIG File.”

7. Copy the CONFIG file back to the print server and then reset the device by using the commands:

ftp NAME

ftp>put CONFIG

ftp>get RESET

Quit by using the command:

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 141 142

No comments

Netgear PS100 User Manual Page 73