Netgear PS100 User Manual download pdf (Page 25)

NetGear Print Server Manual

TCP/IP

The TCP/IP configuration screen is used to configure the IP address of the print server. Figure 3-3

shows the TCP/IP configuration screen and following table lists its fields, describes the functions, and

explains how to provide information in each field.

Figure 3-3 TCP/IP Configuration Screen

TCP/IP Configuration Fields

DHCP Client

This field allows you to enable or disable the print server's ability to get its IP address from a DHCP

(Dynamic Host Configuration Protocol) server. When disabled, you can provide a fixed IP address in the

following fields. If DHCP client is enabled, the fields that follow are not used.

IP Address

This IP address is assigned to the print server. If you have a private LAN and do not plan to connect to

the TCP/IP based internet, NETGEAR recommends that you use the address from the IETF-designated

private addresses (for example, 192.168.x.x or 10.x.x.x).

Subnet Mask

This subnet mask defines the range of addresses that are reachable on your local LAN. For example, in

a network with a NETGEAR router, the default subnet mask is usually 255.255.255.0.

Gateway

Address

This is the IP address of the router on your network. For example, in a network with a NETGEAR router,

the gateway address is usually 192.168.0.1.

Save

Cancel

Buttons

Save:

After the configuration, click on ‘Save’ button to save the value permanently to Print Server.

Cancel:

If changed something that is not good, click on ‘Cancel’ button will load the value back from the print

server. No modification will be made.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 141 142

No comments

Netgear PS100 User Manual Page 25