Netgear Printer PS101 User Manual download pdf (Page 11)

Troubleshooting

The LINK light is not lit

The print server has no power.

• Make sure the power adapter is properly connected to the print server.

• Make sure the power adapter is properly connected to a functioning power outlet. If it is

in a power strip, make sure the power strip is turned on. If it is plugged directly into the

wall, verify that it is not a switched outlet.

• Make sure you are using the correct NETGEAR power adapter supplied with your

print server.

The printer is not on or there is a connection problem.

• Make sure the printer is turned on.

• Make sure the connector is securely plugged in at the print server and the printer.

There is a network hardware connection problem.

• Make sure the connectors are securely plugged in at the print server and the network

device (hub, switch, or router).

• Make sure the network device is turned on.

• Be sure the correct cable is used. In most instances, use a Category 3 (or higher) Ethernet

patch cable. If the network device has Auto Uplink

™

(MDI/MDIX) ports, you may use a

cross-over cable.

The ALERT light is lit.

• Turn the printer off and unplug the print server’s power adapter. Turn the printer on and

then plug in the print server’s power adapter.

• Contact NETGEAR if this doesn’t solve the problem.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Netgear Printer PS101 User Manual Page 11