Netgear PR2000 User Manual Page 41

  • Download
  • Add to my manuals
  • Print
  • Page
    / 145
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 40
genie BASIC Settings
41
Trek N300 Travel Router and Range Extender PR2000
5. Select BASIC > Wireless.
6. (Optional) Change the following wireless settings as needed.
Region.
The location where the Trek is used. Select from the countries in the list. In
Asia, the region is fixed to Asia and is not changeable.
Name (SSID). The SSID is also known as the wireless network name. Enter a
32-character (maximum) name in this field.
This field is case-sensitive. The default
SSID is randomly generated, and NETGEAR recommends that you do not change
this setting.
Channel.
The wireless channel the gateway uses. Enter a value from 1 through 13.
(For products in the North America market, only Channels 1 through 11 can be
operated.) Do not change the channel unless you experience interference (shown by
lost connections or slow data transfers). If this happens, experiment with different
channels to see which is the best.
When you use multiple access points, it is better if adjacent access points use
dif
ferent radio frequency channels to reduce interference. The recommended channel
spacing between adjacent access points is five channels (for example, use Channels
1 and 6, or 6 and 11).
The channel can be changed only when the Trek is operating in wired WAN mode.
For more information about connection modes, see Internet Setup on page 34.
Mode. Up to 300 Mbps is the default setting, which allows 802.1
1n and 802.11g
wireless devices to join the network. The other settings are Up to 54 Mbps and Up to
145 Mbps.
Enable SSID Broadcast. This feature allows the T
rek to broadcast its SSID so
wireless stations can see this wireless name (SSID) in their scanned network lists.
This check box is selected by default. To turn off the SSID broadcast, clear this check
box.
Enable W
ireless Isolation. If this check box is selected, wireless clients (computers
or wireless devices) that join the network can use the Internet, but cannot access
each other or access Ethernet devices on the network.
Page view 40
1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 144 145

Comments to this Manuals

No comments