Netgear Switch M4100 User Manual download pdf (Page 368)

100

101

368 | Chapter 19. Switch Stacks

ProSafe M4100 and M7100 Managed Switches

Move the Stack Master to a Different Unit

This example is provided as CLI commands and a Web interface procedure.

CLI: Move the Stack Master to a Different Unit

1. Using the movemanagement command, move the master to a different unit number. The

operation takes between 30 seconds and 3 minutes depending on the stack size and

configuration. The command is movemanagement <fromunit-id> <tounit-id>.

2. Make sure that you can log in on the console attached to the new master

. Use the show

switch command to verify that all units rejoined the stack.

3. NETGEAR recommends that you rest the stack with the reload command after moving the

master

Web Interface: Move the Stack Master to a Different Unit

1. Select System > Management > Basic > Stack Configuration.

A screen similar to the following displays.

2. In the Management Unit Selected list, select 2.

A warning window displays.

3. Click the OK button.

4. Click Apply.

Note: If you move a master to a different unit, you might lose the

connection to the switch because the IP address could change if the

switch gets its IP address using DHCP.

1 2 ... 363 364 365 366 367 368 369 370 371 372 373 ... 558 559

Comments to this Manuals

No comments

Netgear Switch M4100 User Manual Page 368

Comments to this Manuals

Related products and manuals for Networking Netgear Switch M4100