Netgear Music Player User Manual download pdf (Page 43)

WI-FI SETUP AND PASSWORD HELP

Background

Why Wi-Fi?

With SoundBridge’s wireless functionality, you can stream music from computers on your

wireless network to one or more Wi-Fi enabled SoundBridge devices via your wireless access

point (WAP). You can even connect up to ﬁve SoundBridges to one iTunes music library and

listen to different tunes in every room of your house.

Wi-Fi Hardware

For a list of compatible Wi-Fi access points that Roku has tested with SoundBridge, please visit

www.rokulabs.com/support.

Wi-Fi Setup Instructions

1. Verify that your wireless network is up and running on your computer. If you are setting

up this wireless network for the ﬁrst time, please make sure that you have followed your

wireless vendor’s instruction manual for proper conﬁguration of your wireless access point.

2. Remove both the left and right end caps of SoundBridge by pressing on the two release

tabs labeled “push.” If your SoundBridge is currently powered on, press Standby on your

remote and then disconnect SoundBridge from power by unplugging the AC power cord.

3. Remove the CompactFlash wireless card from its packaging and insert the card into the CF

slot on the left side of SoundBridge. Make sure that the “Roku” label and two small status

lights are facing away from you as you gently push the card into place. (Note: The LED lights

will not be illuminated until you power on SoundBridge.) Be careful, forcing the card into

position may damage your device.

4. If you had been previously using a wired Ethernet connection, disconnect the cord from

the SoundBridge. Make sure you have only the Wi-Fi card or the wired Ethernet

connection attached to the device — never both at the same time.

5. Run your music server software on the computer connected to your wireless network.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 69 70

No comments

Netgear Music Player User Manual Page 43