Netgear HA311 User's Guide Page 40

  • Download
  • Add to my manuals
  • Print
  • Page
    / 45
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 39
40
A
PPENDIX
A—
T
ROUBLESHOOTING
PROBLEM CAUSE SOLUTION
No lights are lit on
the Wireless PCI
Adapter.
The wireless card is not
inserted into the PCI slot on
your desktop PC properly Or
the proper HA311 Wireless
PCI Adapter driver is not
loaded.
• Remove and reinsert the Wireless PCI
Adapter.
• Check the device manager in Windows
to see if the adapter card is properly
recognized in the Windows operating
system. Reload the driver if necessary.
• Try to install the Wireless PCI Adapter in
different PCI slot if it’s available.
The two LED’s are
blinking
alternately.
The Wireless PCI Adapter is
not associated to any access
point properly. You may not
have configured the wireless
parameters of the wireless
nodes to be the same as the
access point.
• The access point may not be powered
on.
• The access point and the HA311
Wireless PCI Adapter are not configured
with the same wireless parameters.
Check the SSID, Turbo mode option,
and WEP encryption settings.
• The access point may be out of range.
Try moving the system closer to the
access point or readjusting the antenna
on the access point. You may also
move the access point to a higher
location for better signal reception by
the Wireless PCI Adapter.
I am associated
and connected to
an access point,
but I cannot see
the other
computers on the
Ethernet side of the
network.
This could be a physical layer
problem or a network
configuration problem.
• Check to make sure that the access
point is physically connected to the
Ethernet network.
• Make sure that the IP addresses and the
Windows networking parameters are all
configured correctly.
Page view 39
1 2 ... 35 36 37 38 39 40 41 42 43 44 45

Comments to this Manuals

No comments