Netgear FA510 Installation Guide download pdf (Page 5)

Model FA510 Network Card Installation Guide

This guide provides you with instructions for installing the Windows Network

Driver. The steps given in these instructions are for users of Windows 98.

If you are using Windows 95, read these instructions thoroughly for an overview

of the steps that are necessary for the installation of the software driver. If you

are installing network cards and drivers on more than one computer operating

with Windows 95, you might find that all versions of Windows 95 do not

respond with the same screens, and windows might open in a different order.

Before you proceed with the installation steps, decide on a name for your

network and for each PC (each name must be only one word). You also need to

have the Windows CD-ROM and the FA510 Drivers and Diagnostics Disk ready

to use in the installation process.

1. Turn on the power to the computer and start Windows 98.

The new hardware is found.

Click on “Next.”

Note:

You must install the network card (instructions on other side of

this guide) before installing the network driver.

Note:

If the “Insert Disk” window opens and the “Please insert the disk

labeled Windows 98...” message appears at any time during the

following process, insert the Windows 98 CD-ROM in Drive D (the

CD-ROM drive) and click on “OK.” Then follow the next step in the

instructions.

Install the Network Driver

< Back Next> Cancel

Add New Hardware Wizard

This wizard searches for new drivers for:

A device driver is a software program that

makes a hardware device work.

PCI Ethernet Controller

1 2 3 4 5 6 7 8 9 10 ... 14 15

No comments

Netgear FA510 Installation Guide Page 5