Netgear GS516TP-100EUS Datasheet download pdf (Page 21)

Installation

GS516TP Gigabit Smart Switch

Connect Devices to the Switch

The following procedure describes how to connect computers to the switch’s RJ-45 ports.

The switch contains Auto Uplink technology, which allows the attaching of devices using

either straight-through or crossover cables.

Figure 5. Connecting devices to the switch

Connect each computer to an RJ-45 network port on the switch front panel. Use a Category 5

(Cat 5) unshielded twisted-pair (UTP) cable terminated with an RJ-45 connector to make

these connections.

Note: Ethernet specifications limit the cable length between the switch and

the attached device to 100 meters (328 feet).

 To connect devices to the switch:

1. Connect a Cat 5 cable to the device.

2. Connect the other end of the Cat 5 cable from the device into an RJ-45 network port located

on the switch front panel.

Apply AC Power

The smart switch does not have an On/Off switch. Power is controlled by the power cord

connection.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 30 31

No comments

Netgear GS516TP-100EUS Datasheet Page 21