Netgear GS516TP-100EUS Datasheet download pdf (Page 12)

Physical Description

GS516TP Gigabit PoE Smart Switch

The following figure illustrates the smart switch back panel.

Figure 2. Back panel

The back panel contains a power connector.

LED Designations

This section describes the designations of the LEDs found in the front panel of the smart

switch.

Port LEDs

The following table describes the RJ-45 port Link/ACT and PoE port status LED

designations.

Table 2-1. Port LEDs

LED Designation

Link/ACT LED mode for copper

ports 1–16

Link/ACT Mode LED:

• Off. No link is established.

• Solid green . A valid 1000 Mbps link is established.

• Blinking green. The port is transmitting or receiving packets at

1000

Mbps.

• Solid yellow . A valid 10/100 Mbps link is established.

• Blinking yellow . The port is transmitting or receiving packets

10/100 Mbps.

PoE Status LED for PoE ports

1–8

• Off . No PoE powered device (PD) is connected.

• Solid green . The PoE powered device (PD) is connected and the

port is supplying power successfully.

• Solid yellow . Indicates that one of the following failures resulted in

stopping power to that port:

- There is a short circuit on PoE power circuit.

- The PoE power demand exceeds power available.

- The PoE current exceeds PD’s classification.

- The supplied power is out of proper voltage band (44–57 VDC).

Power connector

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 30 31

No comments

Netgear GS516TP-100EUS Datasheet Page 12