Netgear FS 750 User Manual download pdf (Page 28)

installation 4-4

Connecting Devices to the Switch

The following procedure describes how to connect devices to the switch’s RJ-45 ports.

When attaching devices to an FS726 or an FS750, the switch’s support for Auto

Uplink technology allows you to attach devices using either straight-through or

crossover cables (for more information about Auto Link‘ technology, refer to "Auto

Uplink " on page 12).

7. Connect each device to an RJ-45 network port on the switch’s front panel (see

Figure 4-2).Use Category 5 (Cat5) unshielded twisted-pair (UTP) cable terminated

with an RJ-45 connector to make these connections.

Figure 4-2.Connecting Devices to the Switch

Note: Ethernet specifications limit the cable length between the switch and the

attached device to 100 m (328 ft).

Front Panel of the Model FS726 or Model FS750 Switch

(Model FS726 shown)

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 51 52

No comments

Netgear FS 750 User Manual Page 28