Netgear WN2000RPTv3 Installation Guide Page 1

WN2000RPT WiFi Range Extender Installation Guide

102. Open a web browser window from the same computer or mobile device.The browser takes you directly to the NETGEAR genie® smart setup.Note: If you

114. Type the network passphrase (also called a password or security key) in the PassPhrase field and click the Continue button.5. Type the name (SSID

12The settings are applied and the following screen displays:6. Use a WiFi network manager on the computer or mobile device to connect to the extender

137. Select the check box and click the Continue button.8. Click the Finish button.

149. Unplug the extender and move it to a new location closer to an area with a poor WiFi signal.The location that you choose must be within the range

15Connect Ethernet-Enabled DevicesAfter the extender is connected to your existing WiFi network, you can use the extender to connect up to four device

16 To connect an Ethernet-enabled device to your WiFi router or access point:1. Set up the extender.For more information, see Place the Extender and

17Access the Extender SettingsAfter installation, you can log in to the extender to view or change the extender’s settings.  To log in to the extende

18Frequently Asked QuestionsYou can find more information about your product in the user manual, which is available at http://support.netgear.com.The

19Will the extender work if I connect it to the router with an Ethernet cable?No. The extender is designed to connect wirelessly to the router or acce

2Getting StartedThe NETGEAR WiFi Range Extender increases the distance of a WiFi network by boosting the existing WiFi signal and enhancing the overal

SupportThank you for selecting NETGEAR products. After installing your device, locate the serial number on the label of your product and use it to reg

3Meet Your ExtenderBefore you install your extender, familiarize yourself with its LEDs, buttons, and ports.Front PanelLink Rate LEDStatus LEDDevice t

4Rear PanelRestore Factory Settings buttonEthernet portsPower inputPower On/Off button

5LED DescriptionsUse the LEDs during installation to find the best location for the extender or to monitor the extender performance.Link Rate LED This

6Install the ExtenderPlace the extender, apply power, and connect it to your WiFi network.Place the Extender and Apply Power1. Place your extender in

7Connect with WPSWi-Fi Protected Setup (WPS) lets you easily join a secure WiFi network without typing the network name and password.WPS does not supp

83. Find the new extender network name.The extender’s wireless network name (SSID) changes to your existing WiFi network name, with _EXT at the end of

9Connect with NETGEAR genie Smart Setup1. Use a WiFi network manager on a computer or mobile device to find and connect to the NETGEAR_EXT (SSID) WiFi