Netgear EX6100 Installation Guide download pdf (Page 5)

Install the WiFi Extender

Place the extender, apply power, and connect it to your WiFi network.

Place the Extender and Apply Power

1. Place your extender in the same room as your WiFi router.

Note: Proximity to the WiFi router is required only during the

initial setup process.

2. Plug the extender into an electrical outlet.

The Power LED lights green. If the Power LED does not

light, press the Power button.

3. Make sure that the switch on the extender is set to Extender.

Connect to an Existing WiFi Network

To extend the range of your WiFi network, you must connect the

extender to your existing WiFi network. You can do this in one of two

ways:

• Connect with WPS. For more information, see Connect with

WPS on page 6.

• Connect with genie Smart Setup. For more information, see

Connect with NETGEAR genie Smart Setup on page 8.

1 2 3 4 5 6 7 8 9 10 ... 19 20

No comments

Netgear EX6100 Installation Guide Page 5