Netgear ANT2409v2 Installation Guide download pdf (Page 6)

Installation Guide for the 9 dBi Omni-directional Antenna ANT2409

1-2

v1.0, April 2008

• Lightning Arrestor

• Reverse N/SMA Adapter

• Antenna mounting assembly (tube, grommet, 2 brackets, screws, washers)

• L shape bracket for top & ceiling mounting

• Screws, bolts, washers, U-bolts and plastic anchors

• This Installation Guide, and a Warranty and Support Information card

If any of the parts are incorrect, missing, or damaged, contact your NETGEAR

dealer. Keep the carton, including the original packing materials, in case you need

to return the product for repair.

To obtain optimal results in extending wireless range with antenna installations,

consult a qualified professional installer for site survey and installation assistance.

Antenna cable for connecting the wireless device is sold separately. Please use a

NETGEAR model ACC-10314-01, 02, 03, 04, or 05 cable.

In the U.S., the ANT2409 antenna should only be used with devices that have

been FCC approved for use with it. Please check the NETGEAR website at

http://www.NETGEAR.com/go/antennas_fcc for an updated list of FCC approved

devices.

For Europe, use of any antenna requires careful planning and extra consideration

to comply with EU emissions and health standards and regulations. Antenna

installation must comply with the maximum level authorized by each country.

Please check the NETGEAR website at

http://www.NETGEAR.com/go/antennas_eu for a list of restrictions and approved

devices.

Note: A ground cable is not included but required for outdoor

installation. The grounding cable must be equivalent or better

than: AWG 10, UL 1015, Stranded, 600 V, 105

C, green or

green/yellow insulation, 2 clip of 5.5 mm inner diameter

cramped at both ends, cable no longer than 5 meters

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

No comments

Netgear ANT2409v2 Installation Guide Page 6