Installation Guide for the 9 dBi Omni-directional Antenna ANT2409
2-6
v1.0, April 2008
2. Locate the primary detachable antenna. Remove the antenna and connect the
other end of NETGEAR cable ACC-10314-01, 02, 03, 04 or 05 to this port.
3. After attaching your new 9dBi antenna, reconnect your wireless device to the
network and turn it on.
Figure 2-6
Note: On access points with two antennas, if you are only replacing
one antenna, be sure to replace the primary antenna and do
not remove the secondary antenna.
(provided)
Comments to this Manuals