Netgear ANT2409v2 Installation Guide Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
Installation Guide for the 9 dBi Omni-directional Antenna ANT2409
2-5
v1.0, April 2008
1. Connect the grounding cable (not included) from the lightning arrestor to the
ground of the building.
Grounding cable: The grounding cable must be equivalent or better than:
AWG 10, UL 1015, Stranded, 600 V, 105
o
C, green or green/yellow
insulation, 2 clip of 5.5 mm inner diameter cramped at both ends, cable no
longer than 5 meters.
2. Screw the N/SMA Reverse Adapter on the lightning arrestor (clockwise) on
the second RF port. Connect a NETGEAR cable model ACC-10314-01, 02,
03, 04 or 05 (sold separately) to the adapter.
3. Locate the primary detachable antenna on the wireless access point. Remove
the antenna and connect the other end of the NETGEAR cable ACC-10314-
01, 02, 03, 04 or 05 to this port.
4. After attaching your new 9 dBi antenna(s), reconnect your wireless device to
the network and turn them on.
Connecting the Antenna for an Indoor Installation
In the procedure “First, Assemble and Mount the Antenna” on page 2-1, the
antenna should have been assembled for indoor installation using a NETGEAR
cable ACC-10314-01, 02, 03, 04 or 05 and the reverse N/SMA adaptor connected
to the antenna. The provided 2m cable should not have been used.
To connect the antenna:
1. Turn off your wireless unit.
Warning: The lightning arrestor and appropriate ground cable must be
used for outdoor installation. NETGEAR does not assume
any responsibility in case of hazard resulting of non-
compliance with these instructions.
Note: On access points with two antennas, if you are only replacing one
antenna, be sure to replace the primary antenna and do not
remove the secondary antenna
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Comments to this Manuals

No comments