Netgear ETHERNET SWITCH SW108 User Manual download pdf (Page 23)

Installation Guide for the Model SW108 Ethernet Switch

Installation 4-3

Set the FDX or HDX toggle switches on the rear panel for the selected duplex mode.

A hub and repeater use a common collision domain for all communications and cannot

support full-duplex mode. When connecting any of the 10 Mbps ports on the switch to a

hub, set the port to HDX. When connecting to a PC, a server, or another switch, the duplex

setting for the port must be the same as the duplex setting on the PC, server, or other switch

Connect one end of the DC power adapter cable to the power outlet on the rear panel of

the switch and the other end of the power adapter cable to the wall outlet.

Verifying Installation

When the installation is complete and power has been applied to the switch, the following

conditions should exist:

• The Power LED on the front panel is on.

• The Link LED on each connected port is on.

• The Rx/Tx/Collision LED on the connected port blinks green when data is being

received by the port and blinks yellow when data collision is occurring on the port.

If you encounter any problems, refer to Chapter 5, “Troubleshooting.”

Note:

Whenever a port changes between FDX and HDX mode, the Model SW108

switch resets and trafﬁc in all ports temporarily stops. When the switch resets, the list

of learned addresses is not affected.

SW108.BK Page 3 Friday, June 27, 1997 10:48 AM

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

No comments

Netgear ETHERNET SWITCH SW108 User Manual Page 23