Netgear XM128U User Manual Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 42
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
Getting Started Using FirstGear for the Model XM128U ISDN Digital Modem
Installation 3-3
2.
Connect the other end (female end) of the 25-pin straight cable to the serial (COM) port
on your computer.
3.
Using the special ISDN cable that is included, connect the larger end of the cable to the
ISDN port on the back of the Model XM128U modem.
4.
Connect the smaller end of the ISDN cable to the wall outlet installed by your telephone
company.
5.
Insert the round end of the power adapter in the POWER connector on the rear panel.
6.
Plug the power adapter into an AC wall outlet.
7.
Turn the power on to your Model XM128U modem.
8.
Turn the power on to your computer.
Verifying Hardware Installation
When the installation is complete and power applied to the modem, a self-test sequence begins.
The B1, B2, and AA LED lights blink on and then off again. After this cycle is complete, the PWR
(power) LED remains on.
If the test routine fails, the D LED blinks. Refer to
Reference Guide for the Model XM128 ISDN
Digital Modem
for more information about the self-test and the error codes.
Installing Software for Windows
This section contains information about installing the Windows 95 and Windows NT
®
drivers and
about configuring Dial-Up Networking.
Note:
If your computer has a 9-pin serial connector, use a 25-pin to 9-pin converter
(25-pin male to 9-pin female). If you have a Macintosh, a special cable is needed for the
connection.
Xm128u_bk.fm Page 3 Wednesday, February 4, 1998 4:32 PM
Page view 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 41 42

Comments to this Manuals

No comments