Netgear 771S User Manual download pdf (Page 8)

AirCard 77Xs/34xU AT Command Reference

8 Proprietary and Confidential 4114487

Result codes

Result codes are not shown in the command tables unless special conditions

apply. Generally the result code OK is returned when the command has been

executed. ERROR may be returned if parameters are out of range, and is

returned if the command is not recognized or is not permitted in the current state

or condition of the modem.

References

This guide covers the command sets used by OEMs, designers and testers of

NETGEAR AirCard devices, plus general operational use commands.

You may also want to consult the other documents available on our website at

www.netgear.com.

Terminology and acronyms

This document makes wide use of acronyms that are in common use in data

communications and cellular technology.

Current firmware versions

Version

To determine your firmware revision, enter the identification command AT+GMR.

Upgrading

If your modem firmware is an earlier version, you can acquire updated firmware

by visiting support.netgear.com and searching by your product model number.

Document structure

This document describes the proprietary commands listed in the tables below—

each table corresponds to a specific chapter.

AT Password Commands—Commands used to enable access to password-

protected AT commands and to set the AT command password.

Table 1-1: AT password commands

Command Description Page

!ENTERCND Enable access to password-protected commands 14

!SETCND Set AT command password 14

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 59 60

No comments

Netgear 771S User Manual Page 8