Netgear Computer Hardware 5200 User Manual download pdf (Page 30)

Maintenance

NETGEAR ReadyDATA 5200

System Components

You can replace system components on your ReadyDATA 5200, EDA2000, or EDA4000.

Power Supply

If either of the two power supply modules fails, the other module takes the full load and allows

the system to continue operation without interruption. The power diagnostic LED illuminates

until the failed unit is replaced.

You do not need to shut down the system to replace

a power supply unit. The backup power

supply module keeps the system operating while you replace the failed hot-swappable power

supply. Replace a failed power supply with the same model.

 To replace a power supply:

1. Unplu

g the AC power cord from the failed power supply module.

2. Depress the locking t

ab on the power supply module and use the rounded handle to pull it

straight out.

3. Push the new

power supply unit into the power bay until you hear a click.

4. Secure the

locking tab on the unit.

5. Plug the AC powe

r cord back into the unit.

System Interior

You must access the inside of your ReadyDATA 5200, EDA2000, or EDA4000 to replace a

fan or battery.

 To access the system interior:

1. Gra

sp the two handles on either side and pull the unit straight out until it locks.

The unit is locked when you hear a click sound.

2. Press the two

buttons on the top of the chassis to release the top cover.

3. Lif

t the top cover from the chassis to gain full access to the inside of the system.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36 37 38

No comments

Netgear Computer Hardware 5200 User Manual Page 30